Specifications

4-16
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Chapter 4 Configuring the CDS
System Level Configuration
Step 4 If the Content Storage feature is not enabled, you must reload the service groups.
a. Choose Maintain > Services. The Services Restart page is displayed.
b. From the drop-down list, choose the IP address or nickname of the server and click Display.
c. Check the Reload Service Groups check box and click Submit.
To clear the fields and start over, click Reset.
Note Any changes (this includes additions, deletions, or modifications) to the headend setup require
a reload of the service groups. See the “Restarting the Services” section on page 7-15 for more
information. If the Content Storage feature is enabled, you do not need to reload service groups.
To view the settings, choose the IP address and associated QAM type.
To edit the settings, choose the IP address and associated QAM type, enter the new settings, and click
Submit.
To delete the headend setup for a specific QAM, choose the IP address and associated QAM type and
click Delete.
Headend Setup for All Other ASI QAM Types
To configure a GQAM Shared, NSG-8108, NSG-9000, SA xDQA, MOTO Sem8, MOTO Sem12, or
GigE Gen device for ASI streaming, do the following:
Step 1 After selecting the IP address and associated GQAM Shared (Figure 4-4), enter the headend setup
settings as appropriate. See Table 4-7 for descriptions of the fields. Figure 4-7 shows the Headend Setup
page for a GQAM Shared.
Figure 4-7 Headend Setup—GQAM Shared with ASI Streaming Mode