Specifications

4-14
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Chapter 4 Configuring the CDS
System Level Configuration
Step 3 If the Content Storage feature is not enabled, you must reload the service groups.
a. Choose Maintain > Services. The Services Restart page is displayed.
b. From the drop-down list, choose the IP address or nickname of the server and click Display.
c. Check the Reload Service Groups check box and click Submit.
To clear the fields and start over, click Reset.
Note Any changes (this includes additions, deletions, or modifications) to the headend setup require
a reload of the service groups. See the “Restarting the Services” section on page 7-15 for more
information. If the Content Storage feature is enabled, you do not need to reload service groups.
To view the settings, choose the IP address and associated QAM type.
To edit the settings, choose the IP address and associated QAM type, enter the new settings, and click
Submit.
To delete the headend setup for a specific QAM, choose the IP address and associated QAM type and
click Delete.
GQAM Headend Setup
To configure a gigabit Quadrature Amplitude Modulation (GQAM) device for ASI streaming, do the
following:
Step 1 After selecting the IP address and associated QAM type (Figure 4-4), enter the GQAM port number in the
GQAM port number field. The GQAM port is the UDP port number the QAM device uses to receive
streams. Figure 4-6 shows the Headend Setup page for a GQAM with ASI streaming.