Specifications

4-11
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Chapter 4 Configuring the CDS
System Level Configuration
c. Check the Reload Service Groups check box and click Submit.
To clear the fields and start over, click Reset.
Note Any changes (this includes additions, deletions, or modifications) to the headend setup require
a reload of the service groups. See the “Restarting the Services” section on page 7-15 for more
information. If the Content Storage feature is enabled, you do not need to reload service groups.
You can view the list of configured service groups from the Select Service Group drop-down list in the
Remove Existing Service Group section of the page.
To delete a service group, choose it from the Select Service Group drop-down list and click Delete.
ASI Streaming
To begin configuring the headend setup for ASI streaming, choose the IP address and associated QAM
type. If the IP address is not listed, then you have not added the device in the QAM Gateway page. See
the “Configuring QAM Gateways” section on page 4-4 for more information.
Note If Bulk Configuration is enabled, the Configuration File Location field is displayed, along with the
Browse and Import buttons. To import a Bulk Configuration XML file, click Browse to locate the file,
then Import to import the file. The status of the import is displayed in the left panel.
For information on enabling the Bulk Configuration feature, see the “Bulk Configuration” section on
page F-5. For information about creating a Bulk Configuration file for ASI streaming Headend Setup,
see the “QAM Gateway and Headend Setup Bulk Configuration for ASI Streaming” section on page B-4.
If there are many QAM devices (for example, 100), the import may take a few minutes. This is because
the TSID Ins and the TSID Outs must be checked against all the QAM TSID Ins and TSID Outs to ensure
uniqueness.
Figure 4-4 shows the QAM IP drop-down list expanded.
Figure 4-4 Headend Setup Page