Specifications

4-10
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Chapter 4 Configuring the CDS
System Level Configuration
To configure a fake service group for a barker stream, do the following:
Step 1 Configure the broadcast QAM on the QAM Gateway page. See the “Configuring QAM Gateways”
section on page 4-4.
Step 2 Configure the fake service group, and input transport stream ID (TSID in) and output transport stream
ID (TSID out) as appropriate for the barker stream broadcast.
Caution The service group, TSID In, and TSID Out for barker stream broadcasting should not be
known to the Digital Network Control System (DNCS).
Step 3 Configure the barker stream using the fake service group you just configured. See the “Configuring
Barker Streams” section on page 4-87.
Note Any changes (this includes additions, deletions, or modifications) to the headend setup require
a reload of the service groups. See the “Restarting the Services” section on page 7-15 for more
information. If the Content Storage feature is enabled, you do not need to reload the service
groups.
Gigabit Ethernet Streaming
To configure the headend setup for gigabit Ethernet streaming, do the following:
Step 1 Choose Configure > System Level > Headend Setup. The Headend Setup page is displayed.
Note If Bulk Configuration is enabled, the Configuration File Location field is displayed, along with
the Browse and Import buttons. To import a Bulk Configuration XML file, click Browse to
locate the file, then Import to import the file. The status of the import is displayed in the left
panel.
For information on enabling the Bulk Configuration feature, see the “Bulk Configuration”
section on page F-5. For information about creating a Bulk Configuration file for gigabit
Streaming Headend Setup, see the “Headend Setup with Gigabit Ethernet Streaming Bulk
Configuration” section on page B-3.
Step 2 Enter the service group number in the Service Group Number field. After the number has been
submitted, the new service group is added to the Remove Existing Service Group list.
Step 3 From the Stream Group drop-down list, choose the stream group that will stream to this service group.
For more information on creating Stream Groups, see the “Configuring Stream Groups” section on
page 4-58.
Step 4 Click Submit.
Step 5 If the Content Storage feature is not enabled, you must reload the service groups.
a. Choose Maintain > Services. The Services Restart page is displayed.
b. From the drop-down list, choose the IP address or nickname of the server and click Display.