Specifications

4-9
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Chapter 4 Configuring the CDS
System Level Configuration
To delete a QAM gateway, choose the QAM IP address, click Next, and then click Delete QAM.
Configuring the Headend Setup
The Headend Setup page is used to configure service groups for gigabit Ethernet streaming, Service
groups and transport stream mapping for ASI streaming, and fake service groups for barker streams.
Note The Headend Setup page is not available if the Stream Destination is set to IPTV. For more information,
see the “Stream Destination” section on page F-4.
The Headend Setup page differs depending on the streaming mode configured.
Note The Streaming Mode is set at the Array Level on the Streamer ISA page. See the “Configuring the
Streamer for BMS Connectivity” section on page 4-45.
Note You must first add the QAM gateway through the QAM Gateway page before you can configure the
headend setup for a specific QAM device. See the “Configuring QAM Gateways” section on page 4-4.
This section covers configuration for:
• Service Groups for Barker Streams
• Gigabit Ethernet Streaming
• ASI Streaming
Service Groups for Barker Streams
Note The Barker Stream feature is optional and is listed only on the Array Level left-panel menu if it is
included in your deployment.
One way to broadcast barker streams is to configure a fake service group on the broadcasting QAM
device. Figure 4-3 shows an example of a fake service group.
Figure 4-3 Fake Service Group Example
Streamer NSG Broadcast QAM Device
99001 89001
Service
Group
79001
RF
GigE
ASI Out 1
ASI Out 2
ASI Out 3
ASI Out 4
Fake Service Group = 79001
Fake TSD Out = 89001
Fake TSD In = 99001
203389