Specifications

D-6
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Appendix D SNMP MIB and Trap Information
RFC Compliance
RFC Compliance
Table D-3 is a list of SNMP RFC standards.
cdstvSysHealthReading Integer Current reading (value) of the system health
parameter; for example, fan speed, voltage, or
temperature. Fan speed is expressed in
revolutions per minute (rpm), voltage in
millivolts (mV) and temperature in degree
Celsius. For chassis intrusion and power-supply
failure, 1 denotes an error condition, and 0
denotes normal condition.
cdstvSysHealthHighLimit Integer Higher limit (threshold) of the system health
parameter. Voltage is expressed in mV and
temperature in degree Celsius. Not applicable
for other parameters such as fan speed.
cdstvSysHealthLowLimit Integer Lower limit (threshold) of the system health
parameter. Fan speed is expressed in rpm and
voltage in mV. Not applicable for other
parameters such as temperature.
cdstvSysHealthStatus 1—Normal
2—Low
3—High
4—Not-OK
Current status of the system health parameter.
The not-ok value applies to power supply failure
and chassis intrusion, because high and low
limits do not apply to these parameters.
Table D-2 System Health SNMP Trap Objects
Descriptor Possible values Description
Table D-3 SNMP RFC Standards
RFC Standard Title
RFC 1155 (STD0016) Structure and Identification of Management Information for
TCP/IP-based Internets
RFC 1157 (STD0015) Simple Network Management Protocol (SNMP)
RFC 1212 (STD0016) Concise MIB Definitions
RFC 1213 (STD0017) Management Information Base for Network Management of
TCP/IP-based internets:MIB-II
RFC 2790 (Draft
Standard)
Host Resources MIB
RFC 1901(Historic) Introduction to Community-based SNMPv2
RFC 1902 (Draft
Standard)
Structure of Management Information for Version 2 of the Simple
Network Management Protocol (SNMPv2)
RFC 1903 (Draft
Standard)
Textual Conventions for Version 2 of the Simple Network Management
Protocol (SNMPv2)