Specifications

7-18
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Chapter 7 System Maintenance
Software Maintenance
In an active-standby relationship, one server acts as the authority and all streams initiate from this
server. The other servers participating in streaming for the TV Playout application only take over when
the active server goes offline.
In an active-active relationship, all servers participating in the TV Playout application, stream the
content at the same time.
To configure the Barker Stream and Playout Schedule applications, do the following:
Step 1 Choose Maintain > Software > Application Configuration. The Application Configuration page is
displayed (Figure 7-3).
Figure 7-3 Application Configuration Page
Step 2
Choose the Stream Delivery Mode.
Active-Standby—All streams initiate from one server (active). The other servers (standby) only take
over when the active server goes offline.
Active-Active —All servers stream the content at the same time.
Note Stream Failover must be disabled if the Stream Delivery Mode is set to Active-Active. Stream
Failover must be enabled if the Stream Delivery Mode is set to Active-Standby. For more
information on setting Stream Failover, see the “Stream Failover Support” section on page F-3.
Step 3 For Active-Active, check the check box next to each server participating in each application.
Step 4 Click Submit to save the settings.
To clear the fields and start over, click Reset.