Specifications

4-114
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Chapter 4 Configuring the CDS
Server Level Configuration
Starting
Transport Port
Beginning default UDP port number used for stream and stream/cache interfaces. If the
starting transport port is left blank, the default of 48879 is used.
Streamer, ISV
Ending
Transport Port
Ending default UDP port number used for stream and stream/cache interfaces. There is no
default for the ending transport port number.
Streamer, ISV
Cache Port Default UDP port number used for cache traffic between servers. If the cache port is left
blank, the default of 48879 is used.
All servers
Ingest MPEG Settings
PID
Standardization
Informational only. If this field is set to enable, then MPEG-2 video assets have their
program identifiers (PIDs) standardized at ingest so that most assets use the same PIDs.
To change the settings of the Ingest MPEG fields, see the “Configuring Ingest Tuning”
section on page 4-26.
Vau l t, I SV
Sequence End
Remove
Informational only. If this field is set to enable, a SEQ END header that is present at the
end of the asset (and only at the end) is removed on ingest. To change the settings of the
Ingest MPEG fields, see the “Configuring Ingest Tuning” section on page 4-26.
Vau l t, I SV
Rate Standardize Informational only. If this field is set to enable, then MPEG-2 video assets have their rates
standardized at ingest so that most assets use one of two standard rates, 3.75 Mbps for SD
assets or 15 Mbps for HD assets. To change the settings of the Ingest MPEG fields, see
the “Configuring Ingest Tuning” section on page 4-26.
Vau l t, I SV
Fail Ingest Settings
Fail Ingest
Settings Status
Informational only. If the server settings are out of synchronization with the Fail Ingest
configuration settings, a warning message to resubmit the Ingest Tuning page is
displayed.
Vau l t, I SV
Stream Group Information
Stream Group
Name
Stream Group ID
These fields display the Stream Group Name and Stream Group ID the ISV or Streamer
is a member of. The Stream Group Name and Stream Group ID are informational only. To
configure Stream Groups, see the “Configuring Stream Groups” section on page 4-58.
Streamer, ISV
Streamer Is
Cache
If Streamer Is Cache is enabled, the Streamer can be used as a possible cache-fill source
by a Streamer in a different Stream Group. All Stream Groups that have at least one
Streamer with Streamer is Cache enabled are displayed on the Stream to Cache Map
page, where the Stream Group can be selected as a possible cache-fill source and given a
preference. Only the Streamers with Streamer Is Cache enabled are used as possible
cache-fill sources. The protocol used for cache-fill responses from Streamers is always
CCP. For more information, see the “Mapping Stream Groups to Cache-Fill Sources”
section on page 4-68.
Streamer, ISV
Cache Group Information
Cache Group
Cache Group ID
These fields display the Cache Group Name and Cache Group ID the Caching Node is a
member of. The Cache Group Name is informational only. To configure Cache Groups,
see the “Configuring Cache Groups” section on page 4-65.
Caching Node
Vault Group Information
Vault Group
Vault Group ID
These fields display the Vault Group Name and Vault Group ID the Vault is a member of.
The Vault Group Name is informational only. To configure Vault Groups, see the
“Configuring Vault Groups” section on page 4-61.
Vau l t, I SV
Table 4-39 Server Setup Fields (continued)
Field Description Server Types