Specifications

4-112
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Chapter 4 Configuring the CDS
Server Level Configuration
Note The Auto Populate IPs check box is available when the first applicable interface (for example,
the first stream interface) is configured with an IP address. If the Setting has been selected for
each of the remaining interfaces, checking the Auto Populate IPs check box and clicking Auto
Populate Now automatically enters the next consecutive IP address as the IP Address for the
next interface, and continues to populate all IP Address fields until they are all filled. Any
preexisting IP addresses in the IP Address fields are overwritten.
Step 4 Click Submit to save the settings.
To clear the fields and start over, click Reset.
Configuring the Servers
After a server has been initially configured, the CDSM detects it and the IP address or nickname of the
server is available for selection in the server drop-down lists.
To configure the server settings, do the following:
Step 1 Choose Configure > Server Level > Server Setup. The Server Setup page is displayed.
Step 2 From the Server IP drop-down list, choose the IP address or nickname of the server and click Display.
Step 3 The fields differ for a Vault, Streamer, Caching Node, and ISV server. The ISV server setup page has a
combination of the Vault and Streamer fields. See Table 4-39 for descriptions of the fields and to which
server they apply.
Table 4-37 Interface Fields
Field Description
Setting Choose each interface setting as appropriate. See Table 4-36 for descriptions
of the different interface types.
IP Address IP address for this interface. The IP address set for this interface overrides the
default Source IP setting.
If you are using Layer 3 communication among Vaults, Caching Nodes, and
Streamers, each cache or stream/cache interface must have an IP address.
If you are using Layer 2 communication among Vaults, Caching Nodes, and
Streamers, IP addresses for cache and stream/cache interfaces are optional.
Subnet Mask Subnet mask for this interface.
Transport Port This setting applies only to stream or stream/cache interfaces. This is the UDP
port number for stream traffic. The port number set for this interface overrides
the default transport port setting.
Cache Port UDP port number for cache traffic. The port number set for this interface
overrides the default cache port setting.