Specifications

4-97
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Chapter 4 Configuring the CDS
Array Level Configuration
Figure 4-38 Barker Stream/Playlist for ASI Streaming Page
Step 2
Choose configure new and click Next.
Step 3 In the Number of Contents drop-down list, select the number of content objects for the barker stream
or playlist.
Step 4 Enter the Barker Stream settings as appropriate. See Table 4-34 for a description of the fields.
Step 5 Click Submit.
To clear the fields and start over, click Reset.
Step 6 To play the barker stream, click Start Barker.
Table 4-34 Barker Stream—ASI Fields
Field Description
Barker Name Enter a name for the barker stream. The name can be from 1 to 25 characters in
length and can consist of upper and lower case letters, numbers, and the underscore
(_) or dash (-) symbols.
Service Group
From the Service Group drop-down list, choose a service group that will stream
the barker. All service groups currently configured on the CDS are listed.
Program Number Enter the program number that identifies this barker stream.
Content
From the Content drop-down list, choose the content to use for the barker stream.
By typing the first few characters of the content name, you can jump to that section
of the list.
All content that has been ingested through the BMS or manually ingested is listed
alphabetically.
Loops Enter the number of times the content object will loop. An entry of 0 means infinite
looping.