Specifications

4-95
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Chapter 4 Configuring the CDS
Array Level Configuration
Step 1 Click Configure > Array Level > Barker Stream/Playlists. The Barker Stream page is displayed
(Figure 4-33).
Note The Barker Stream page displays the delivery service mode (active-active or active-standby) for
the Baker Stream application. To change the delivery service mode, see the “Configuring the TV
Playout Application” section on page 7-17.
Figure 4-37 Barker Stream/Playlist for Gigabit Ethernet Streaming Page
Step 2
Choose configure new and click Next.
Step 3 For Type, select either Barker or Playlist.
Step 4 In the Number of Contents drop-down list, select the number of content objects for the barker stream
or playlist.
Step 5 Enter the settings as appropriate. See Table 4-33 for a description of the fields.
Table 4-33 Barker Stream—Gigabit Ethernet Fields
Field Description
Barker Name or
Playlist Name
Enter a name for the barker stream. The name can be from 1 to 25 characters in
length and can consist of upper and lower case letters, numbers, and the underscore
(_) or dash (-) symbols.
Output Channel The output channel used to transmit the barker stream. Only applicable to barker
streams.
Content
From the Content drop-down list, choose the content to use for the barker stream.
By typing the first few characters of the content name, you can jump to that section
of the list.
All content that has been ingested through the BMS or manually ingested is listed
alphabetically.
Loops Enter the number of times the content object will loop. An entry of 0 means infinite
looping.