Specifications

4-88
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Chapter 4 Configuring the CDS
Array Level Configuration
Tip By typing the first few characters of the content name, you can jump to that section of the list.
Step 3 Check the check box next to each QAM IP that will send the specified barker stream.
All QAM devices currently configured on the CDS are listed.
Step 4 In the QAM Port field, enter the port number for each selected QAM device.
Step 5 From the Svc. Group drop-down list, choose the service group for each selected QAM device.
If you have more than one service group associated with a QAM device that you want to configure with
the same barker stream, then repeat the configuration steps for each additional service group.
Step 6 Enter the number of times the content object will loop for each service group selected. An entry of -1
means infinite looping.
Step 7 Click Submit.
To clear the fields and start over, click Reset.
ASI Streaming
To configure barker streams for ASI streaming, do the following:
Step 1 Choose Configure > Array Level > Barker Stream. The Barker Stream page is displayed.
Step 2 Using the Number of Service Groups To Configure drop-down list, choose the number of service groups
you want to receive the barker stream and click Submit. The barker stream fields are displayed
(Figure 4-34).
The maximum number of service groups that can be configured at one time is ten. If you have more than
ten service groups that you want to configure with the same barker stream, configure the first ten service
groups, then configure any additional service groups by repeating these steps.