Specifications
4-41
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Chapter 4 Configuring the CDS
System Level Configuration
Step 3 Enter the Log Level settings as appropriate. See Table 4-16 for descriptions of the fields.
Step 4 Click Submit.
To clear the fields and start over, click Reset.
To delete the log level settings for a facility, select the facility from the drop-down list and click Delete.
Configuring the System Level Syslog
The Syslog configuration page at the System Level and Server Level is used to configure the IP address
and port of the server that is to receive remote logging. The configuration of the syslog server at the
Server Level overrides the System Level settings. For remote logging information to be sent for a facility,
the Remote Log Level must be set on the Logging page. See the “Configuring the System Level
Logging” section on page 4-39 for more information.
To configure the remote logging server, do the following:
Step 1 Choose Configure > System Level > Syslog. The Syslog page is displayed.
Step 2 Check the Enable Remote Logging check box.
Table 4-16 Log Level Fields
Field Description
Local Log Level The Local Log Level drop-down list has the following options:
• Emergency (0)
• Critical (1)
• Alert (2)
• Error (3)
• Warning (4)
• Notice (5)
• Informational (6)
A log level setting includes all the more urgent levels. For example, if the log
level is set to Error (3), then Alert (2), Critical (1), and Emergency (0) log entries
are included as well as Error (3).
Remote Log Level To enable remote logging for the selected facility, select the appropriate log level
from the Remote Log Level drop-down list. The default setting is disable.
Debug Flags Debug messages, if applicable, are configured by setting one or more debug
flags. To select or unselect debug flags, you have the following options:
• To select one debug flag, click the flag.
• To select multiple debug flags, hold down the Ctrl key and click each flag,
or hold down the Shift key and click the beginning flag and ending flag.
• To unselect a debug flag when a group of debug flags are selected, hold
down the Ctrl key and click the flag.