Specifications

4-31
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Chapter 4 Configuring the CDS
System Level Configuration
Step 3 Click Submit.
To clear the fields and start over, click Reset.
Configuring IP Nicknames
The IP nicknames are used as an alternative for the IP address in the CDSM drop-down lists.
To configure an IP nickname for a CDS server or QAM gateway, do the following:
Step 1 Choose Configure > System Level > IP Nickname. The IP Nicknames page is displayed (Figure 4-11).
Rewind Skip When Rewind Skip is enabled, if a rewind trick-mode command is issued and a rewind-restricted segment
is encountered, it is skipped and rewinding continues on the next segment.
When Rewind Skip is disabled (default setting), if a rewind trick-mode command is issued and a
rewind-restricted segment is encountered from an unrestricted segment, the rewinding stops and the
unrestricted segment is played at normal play speed.
As an example, Segment 2 is unrestricted and Segment 1 has the rewind trick-mode speed restricted. If a
rewind command is issued during the playing of Segment 2, rewinding of Segment 2 occurs until the end
of Segment 1 is encountered where the rewind trick-mode is restricted. Rewinding stops and the
unrestricted Segment 2 begins to play at normal speed.
Cache to Application Settings
Library Timeout A network partition could cause the Setup server to wait forever for the remote Stream Groups to respond
to the application for setup requests. The Library Timeout sets the time interval (in microseconds) that the
SetStreamInfo API should wait before considering the remote Stream Group unavailable.
The range is from 1000 to 5000. The default is 2000 (2 seconds).
Dual CAS Settings
Dual CAS Dual conditional access systems (CAS), Cisco/Scientific Atlanta Power Key Encryption System (PKES)
and the Motorola OffLine Encryption Station (OLES), are supported for ISA environments that have
Stream Destination set to IPTV. For information on setting the Stream Destination, see the “Stream
Destination” section on page F-4.
The Dual CAS feature requires that Pre-Encryption support be enabled. In a CDS, the Pre-Encryption
support setting is on the Vault BMS page (Configuring the Vault for BMS Connectivity, page 4-50). In a
VVI, the Pre-Encryption support setting is on the Distributed ISA Setup page in the VVIM (Configuring
Distributed/ Shared ISA Settings, page 4-20) and the VHO ISA Setup page in the Stream Manager
(Configuring VHO ISA Settings, page 4-55).
A field on the Monitor Completed Ingests page indicates whether the ingested content is encrypted or not.
Both clear and encrypted content can be ingested.
Table 4-11 MPEG Tuning Fields (continued)
Field Description