User guide

www.cisco.com
Near end camera control
Using Touch Tones (DTMF) in a call
Near end camera presets
Tap the Camera icon...
During a call, or outside a call, tap the
Camera icon ...
Tap Touch Tones ...
... adjust zoom and pan as
required.
Tap anywhere outside the menu
to exit.
Far end camera control (in a call only)
Tap the name
along the bottom line ...
... then tap
Camera Control.
Adjust zoom and pan as required. Tap Back
or anywhere outside the menu to exit.
Tap Hide camera controls (

) to see the
presets only and tap anywhere outside the menu
(

) to exit the camera preset mode.
Tap an existing preset to make the camera move
accordingly. To dene presets, see
“Adding a
near end camera preset” on page 6.
Sometimes you may be urged to enter touch tones (DTMF) during a call, typically to reach extensions or to provide a pin code.
Use the touch tone keypad. Tap anywhere outside the
keypad to exit.
This works in point-to-point as well as in multisite calls, but only on systems with remotely controllable cameras.


This drop-down list appears if more than one camera is connected.
This drop-down list appears if more than one camera
is connected.
25
Cisco TelePresence System Prole Series, Codec C Series, Quick Set C20, SX20 Quick Set, MX200, MX300 User guide
D14582.09 User guide Prole Series, Codec C Series, Quick Set C20, SX20 Quick Set, MX200, MX300
All contents are copyright © 2010–2012 Cisco Systems, Inc. All rights reserved. Version TC5.1, 02.2012
Contents
Settings
Getting started
Placing calls
Using directories
In-call features
Scheduled meetings
In-call features