User guide

www.cisco.com

Receiving another incoming call

Putting Far end on hold and back again

This is an optional feature that may, or may not, be present on your system. If in doubt, ask your System Administrator.

Assume that you are in a call. This call can

be a point-to-point call or a multisite call.

Furthermore assume that another person

calls you.

You may now:

• Tap ACCEPT & JOIN to include the incoming

call in the conference.

• Tap DECLINE to carry on as you did.

• Tap Accept & Hold Current to accept the call,

while at the same time put the current call on

hold.

• Tap Accept & End Current to accept the call,

while at the same time end the current call.

• Tap Ignore to carry on as you did, without

sending decline signal to the other end.

Even an entire group can be put on hold, so the

above options apply equally well to point-to-point

calls as to multisite calls.

Tap Hold. The far end will be

put on hold immediately.

To enable resume,

tap the name on the

bottom line.

Tap RESUME.

To cancel the action, tap

anywhere outside the dialog box.

Cisco TelePresence System Prole Series, Codec C Series, Quick Set C20, SX20 Quick Set, MX200, MX300 User guide

D14582.09 User guide Prole Series, Codec C Series, Quick Set C20, SX20 Quick Set, MX200, MX300

Contents

Settings

Getting started

Placing calls

Using directories

In-call features

Scheduled meetings

In-call features