User guide

Documentation Updates

Release Notes for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.1

OL-6255-01

Checking Redundancy Settings

In the Redundancy Status Settings table, the description for the Turned Off

redundancy status should be “Not configured.”

The description for Minutes Between Sync should be “Synchronization interval.

(Data synchronized from the active node to the standby node.)”

Configuring Redundancy

The second paragraph should be replaced by the following text: Subsequent

configuration changes can be done on whichever WLSE is in active mode, but the

nodes’ IP addresses should be remain the same as when they were initially

configured. If you need to reconfigure the nodes’ IP addresses, first turn

redundancy off, and then configure the nodes’ IP addresses.

Changes in Backup and Restore and Redundancy Status

The documentation should include the following information:

• If redundancy is not enabled, backup and restore are allowed.

• If redundancy is in active mode, backup is allowed, but restore fails and

generates an error message asking you to turn off redundancy first.

• When restoring, if the backup is performed when redundancy is in active

mode, redundancy is automatically turned off after the restore, and you will

need to reenable it.

• If redundancy is in standby mode, neither backup nor restore are allowed. If

you are trying to run backup, a message appears asking you to run backup on

an active node.

Managing Your WLAN Radio Environment

The Caution note should read AP subnet instead of Layer-2 domain so that the

first sentence reads: The WLSE must register with the WDS in each managed AP

subnet to receive Radio Manager data.

Getting Started with Radio Manager

The note in Step 2 is incorrect and should not appear in the documentation.

Step 5, part f should read: Verify that the WLSE to WDS Authentication Status

column contains the string KeysSetUpWithWDS or Authenticated.

The last paragraph of Step 6 should read: You can also verify this setting by

running the show wlccp wds ap command on the primary WDS in enable mode.