User guide

23
Release Notes for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.1
OL-6255-01
Known and Resolved Problems
CSCsa21277 SSID is disabled after conversion if
Infra-SSID VLAN is not native.
To work around this problem:
1. Make sure the SSID that is mapped to
the Native VLAN is set as
infrastructure SSID before starting the
conversion.
2. If the conversion has already
completed, use WLSE to create an IOS
configuration template to remove the
command infrastructure-ssid from the
SSID that is not the Native VLAN
SSID.
CSCsa21732 HTTP disabled setting is not
converted properly.
Because the HTTP server setting is not
converted properly if it is disabled under
VxWorks, if web-based access to the AP
was initially disabled as a security measure,
security could be compromised after
conversion if the AP becomes
web-accessible.
CSCsa22073 Confusing messages during
repeater conversion failure.
When converting a repeater, the following
failure message is displayed:
Ethernet port is not configured as
primary port.
CSCsa22766 Conversion does not proceed with
a dual mode AP with v3 image if
there is a memory issue.
Conversion fails when converting a dual
mode AP running a v3 image because of
memory issues.
CSCsa24586 Filters/Policies are lost for the AP
after conversion if the AP is across
a slow link.
If you are using a slow WAN link, after
converting an AP from VxWorks to IOS, the
created IP, IP Port, and EtherType filters
and Policy Groups are not converted.
Table 4 Resolved VxWorks to IOS Conversion Bugs in WLSE (Continued)
Bug ID Summary Explanation