User guide

Known and Resolved Problems
22
Release Notes for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.1
OL-6255-01
CSCsa20084 IP protocol faults default action
cannot always be permit any.
For the protocol filter, the converted
configuration has permit any as the default.
CSCsa20102 Cannot telnet to IOS AP after
converting from VxWorks.
When you create a conversion job and then
try to telnet to the AP, the AP indicates that
the telnet lines are not configured with the
telnet line password.
CSCsa20273 Encryption mode is incorrectly set
after conversion on VLANs.
VLAN encryption is set to optional instead
of mandatory.
CSCsa20330 WLSE should check free memory
on an AP before starting VxWorks
to IOS conversion.
If there is not enough available memory in
the VxWorks AP, the conversion fails.
CSCsa20561 Hostname command with spaces
will fail.
The hostname command is missing after
conversion if the sysname contains any
spaces.
CSCsa20622 Missing AAA authentication login
default local command if UsrMgr
is enabled.
Whenever you convert a VxWorks AP that
has the User Manager enabled with at least
one user who has all permissions, WLSE
does not add the following command in the
converted IOS configuration:
aaa authentication login default
local.
Instead, WLSE adds the command ip http
authentication aaa because user manager is
enabled.
CSCsa21112 The Job Summary page has the
wrong MIB variables for
Username and User Manager.
After conversion, on the Job Summary page
in the “VxWorks To IOS Upgrade Security
Check” section, the MIB variables for
Username and enable User Manager are
incorrectly listed.
CSCsa21117 Accounting Service Settings are
not converted correctly.
The accounting server shared secret
information is not converted during the
conversion process.
Table 4 Resolved VxWorks to IOS Conversion Bugs in WLSE (Continued)
Bug ID Summary Explanation