User guide

Known and Resolved Problems
20
Release Notes for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.1
OL-6255-01
CSCsa15394 WLSE 2.7 generates false WDS
0.0.0.0 faults when no WDS is
configured.
If an AP is not registered with any WDS, WLSE
generates a fault saying the AP is registered with
an unmanaged WDS (0.0.0.0) instead of
generating a fault saying “AP is not registered
with any WDS.” If you see a fault that says an
AP is registered with an Unmanaged WDS
0.0.0.0, this means the AP is not registered with
any WDS.
CSCsa20580 Rogue location estimation fails
if the rogue is detected by only
one AP.
If you perform radio monitoring on one AP and
a Rogue AP fault is generated, in Location
Manager, the Rogue AP location estimation
fails.
Table 4 Resolved VxWorks to IOS Conversion Bugs in WLSE
Bug ID Summary Explanation
CSCed78655 Configuration conversion from
VxWorks to IOS has wrong value.
After converting an AP from Vxworks
configuration to IOS configuration, the
converted IOS configuration contains an
incorrect value. If you try to apply the
converted configuration to an IOS AP, the
job fails.
CSCee38616 The MAC address format becomes
bogus after converting from
Vxworks to IOS.
After converting an AP from Vxworks to
IOS, the MAC address format becomes
bogus in the converted configuration file.
CSCsa12094 Configurations lost when
upgrading from converted IOS AP
to IOS.
Configurations are lost when using WLSE
to upgrade from converted IOS AP to IOS.
CSCsa12085 awcDot11UseAWCExtensions = F
is not preserved in VxWorks to IOS
conversion.
When an AP is converted from VxWorks to
IOS, WLSE does not preserve
awcDot11UseAWCExtensions = F. If
Aironet extensions were disabled in
VxWorks, after the conversion, they are
re-enabled.
Table 3 Resolved Problems in WLSE (Continued)
Bug ID Summary Explanation