User guide

Known and Resolved Problems
16
Release Notes for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.1
OL-6255-01
CSCsa13929 Version checking error occurs if
template has 11g plus any 11a
radio parameters.
When you create a template for a dual mode IOS
AP1210 that has any of the 11a interface
parameters and has specific 11g parameters, the
version checking fails to process and gives you
an error that no valid device versions are
supported. This problem occurs only if you
selected the following 11g specific parameters
in the Radio-802.11b/g template:
• Data rates in for 11G
• CCK Transmitter Power (mW)
• OFDM Transmitter Power (mW) and
• Short Slot-Time
There are two workarounds to this problem:
• If you have an 11g radio and want to set the
11g parameters above, create a separate
template for these parameters, save the
template, and then push it to the specific AP.
• After you see the message “Error
processing configuration / No valid device
versions supported,” save the template.
When creating the job with this template,
during the final step of saving the job, the
following message appears:
Currently selected configuration
template does not have valid device
version information.
This template will not be validated
against the selected devices.
Click Save to save the job and the template
will be applied to the AP.
CSCsa14926 TACACS+ secret does not accept
dollar sign.
You cannot use the “$” sign in the authentication
password.
There is no workaround to this problem.
Table 2 Known Problems in the WLSE (Continued)
Bug ID Summary Explanation