User guide

9
Release Notes for the CiscoWorks Wireless LAN Solution Engine, Release 2.11
OL-6775-01
Known Problems
CSCeh39607 Cannot disable fault polling on
WEP Encryption per VLAN fault.
After you enable the fault polling on the WEP
Encryption per VLAN fault, you cannot
subsequently disable fault polling on this
particular fault due to an error message that is
generated.
There is no workaround to this problem.
CSCei04672 Exporting devices to CiscoWorks
LMS 2.5 fails.
You cannot export devices to CiscoWorks LMA
2.5. When you try to export devices, you get the
following error message:
Could not connect to CiscoWorks Server.
There is no workaround to this problem.
CSCsa35554 Weekly and monthly data
aggregation does not happen at
the beginning of the week/month.
The first weekly/monthly aggregation does not
start at the beginning of the week/month. The
first aggregation might happen earlier than the
beginning of the week/month.
After the first weekly/monthly aggregation, all
subsequent weekly/monthly aggregation occurs
every 7 days for weekly or every 30 days for
monthly aggregation from the first time the
aggregation occurred.
There is no workaround to this problem.
CSCsa45830 AP is shown in Monitor mode
after Scanner mode is disabled
and inventory is done.
If an AP is converted from Scanner mode to any
non-Scanner mode while Frame Monitoring is
still requested from that AP, no Fault is
generated to warn the administrator of this
erroneous network configuration.
To work around this problem, place the AP back
into Scanner mode or remove it from the Frame
Monitoring list.
Table 2 Known Problems in the WLSE (Continued)
Bug ID Summary Explanation