User guide

Known Problems
18
Release Notes for the CiscoWorks Wireless LAN Solution Engine, Release 2.11
OL-6775-01
CSCeg46075 Incorrect IOS version is listed
for 2.9 RM operations.
Radio Management operations in WLSE require
the APs to be running the latest 12.3(2)JA IOS
version. Older versions, including 12.2(15)JA,
do not work.
CSCsa35793 After using the command no
http-server accept <ip>
<mask>, WLSE redundancy
fails.
When you issue the command line interface
commands http-server accept <ip> <mask>
and no http-server accept <ip> <mask> and
then configure the server as a Redundancy
Standby server, the redundancy status on the
server gets stuck in starting mode from the
command line interface and cannot be
connected via http (however, it can be connected
using https). The redundancy page shows the
server as a Standby server, but with the Manage
Redundancy option (which should show up if
the server is in Active server mode only).
CSCsa39732 Switches, when pointed at,
display radio port information.
If you select Reports > Current > Device Type
> Switches and point your cursor at the switches
in that group, radio port information is
displayed. The switches do not have radio ports
and this information should not be displayed.
CSCsa39738 The VxWorks template for
dot11CurrentRxAntenna.2 is not
handled well.
When you create a Vxworks template and go to
the 11b Radio Hardware page, select Receive
Antenna as Diversity, and save the template, the
following error message appears:
Following key-value(s), in the current
configuration template, are not
supported:
Key: dot11CurrentRxAntenna.2
Value: diversity
Table 3 Resolved Problems in the WLSE (Continued)
Bug ID Summary Explanation