User guide

Known Problems
10
Release Notes for the CiscoWorks Wireless LAN Solution Engine, Release 2.11
OL-6775-01
CSCsa48733 Selecting a building from the
device tree selects nothing.
When creating a Radio Manager job such as an
AP Scan, if you select the building in which the
APs reside as the selected devices, no devices
are selected when the job is run. Devices are
selected when the floor or an explicit AP is
selected only. This occurs in AP Radio Scan,
Assisted Configuration, and Radio Monitoring.
To work around this problem, select the explicit
APs in the Select Devices step for Assisted
Configuration and Radio Monitoring.
CSCsa57270 AP350 EMF does not always start
when enabled on WLSE.
When WDS reboots, 350 APs might not start
Excessive Management Frame (EMF) detection.
To work around this problem, perform one of
these actions:
• Locate the IDS profile where the device
belongs and reapply EMF settings.
• Remove the device and then add it back to
the Radio Monitoring list to enable EMF.
CSCsb07984 WLSE fails to import devices
from RME 4.0.
You cannot import devices from CiscoWorks
RME 4.0 to WLSE 2.11. When you try to import
devices, you get an error message in the
jobvm.log file.
There is no workaround to this problem.
CSCeh60102 Rogue AP Fault description
before/after upgrade is incorrect.
During a 2.9.1a to 2.11 upgrade, the description
for rogue AP faults changes:
Before: “Device is rogue access point”.
After: “Device state is rogue access point”.
No workaround is required.
Table 2 Known Problems in the WLSE (Continued)
Bug ID Summary Explanation