Specifications

This document may be freely reproduced and distributed whole and intact including this Copyright Notice.

1. Clean the cover of any grease, dirt, or oil before applying the tamper evidence

labels. Alcohol-based cleaning pads are recommended for this purpose. The

temperature of the router should be above 10°C.

2. Tamper evidence labels A and B should be placed so that one half of the label

covers the front panel and the other half covers the enclosure.

3. Tamper evidence label C should be placed so that one half of the label covers the

left upper and lower ENM modules and the other half covers the enclosure.

4. Tamper evidence labels D and E should be placed so that one half of each label

covers the side of right ENM modules and the other half covers the enclosure.

5. Tamper evidence labels F, G, H and I should be placed so that one half of each

label covers the top side of HWIC modules and the other half covers the

enclosure.

6. Tamper evidence label J should be placed over the CF slot.

7. Tamper evidence labels K, L, M and N should be placed on each of the opacity

shields so that one half of each label covers the opacity shield and the other half

covers the enclosure.

8. The labels completely cure within five minutes.

Figures 12, 13 and 14 show the tamper evidence label placements for the 3845.

Figure 12 – Cisco 3845 Tamper Evident Label Placement (Front View)

Figure 13 – Cisco 3845 Tamper Evident Label Placement (Back View)