Specifications

This document may be freely reproduced and distributed whole and intact including this Copyright Notice.

8. Tamper evidence labels H and I should be placed on the top and bottom of the

opacity shield such that the one half of each label covers opacity shield and the

other half covers the enclosure.

9. The labels completely cure within five minutes.

Figures 9, 10 and 11 show the tamper evidence label placements for the 3825. Note that

each diagram only shows certain label placement locations.

Figure 9 – 3825 Tamper Evident Label Placement (Front View)

Figure 10 – 3825 Tamper Evident Label Placement (Back View)

Figure 11 - 3825 Tamper Evident Label Placement (Side View)

For Cisco 3845: