Specifications

This document may be freely reproduced and distributed whole and intact including this Copyright Notice.

Figure 7 – 3825 – Opacity Shield Placement

Figure 8 – 3845 – Opacity Shield Placement

Once the router has been configured in to meet FIPS 140-2 Level 2 requirements, the router

cannot be accessed without signs of tampering. To seal the system, apply serialized tamper-

evidence labels as follows:

For Cisco 3825:

1. Clean the cover of any grease, dirt, or oil before applying the tamper evidence

labels. Alcohol-based cleaning pads are recommended for this purpose. The

temperature of the router should be above 10°C.

2. Tamper evidence label A shall be placed so that one half of the label covers the

top of the front panel and the other half covers the enclosure.

3. Tamper evidence label B shall be placed so that one half of the label covers the

bottom of the front panel and the CF card and the other half covers the enclosure.

4. Tamper evidence labels C and D should be placed so that the one half of the label

covers the enclosure and the other half covers the left and right upper ENM slots.

5. Tamper evidence label E should be placed so that the one half of the label covers

the lower right ENM slot and the other half covers the enclosure.

6. Tamper evidence label F should be placed so that the one half of the label covers

the left upper and lower HWIC slots and the other half covers the enclosure.

7. Tamper evidence label G should be placed so that the one half of the label covers

the right upper and lower HWIC slots and the other half covers the enclosure.