Installation guide

Installing AC Power Supplies in Cisco 2691 Routers

78-13819-01

Replacing the Cisco 2691 Power Supply

Step 2 Hold the cover so the tabs at the rear of the cover are aligned with the chassis bottom.

Step 3 Push the cover toward the rear, making sure that the cover tabs fit under the chassis back panel, and the

back panel tabs fit under the cover.

Step 4 Slide the cover slightly to the left to lock the cover into position (number 1 in Figure 10).

Figure 10 Replacing the Cisco 2691 Router Cover

Step 5 Lower the front of the cover onto the chassis (number 2 in Figure 10).

Step 6 Fasten the cover with the five screws you set aside earlier.

Step 7 Reinstall the chassis on a rack.

Step 8 Reinstall network interface cables.

Step 9 Proceed to the “Electrical Connections for Cisco 2691 Routers” section on page 16.

62490