Leaflet

Verify
Use this section to confirm that your configuration works properly.
The Output Interpreter Tool (registered customers only) (OIT) supports certain show commands. Use the OIT
to view an analysis of show command output.
Catalyst Switches Verification
Catalyst switch that runs Cisco IOS Software show running−config interface interface_type
interface_number
controller−ios#show running−config interface gigabitethernet 2/1
Building configuration...
Current configuration : 190 bytes
!
interface GigabitEthernet2/1
no ip address
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,5,15,20,25,30,35,40,45,50,55,100
switchport mode trunk
end
•
Catalyst switch that runs CatOS softwareshow config mod
controller−catos> (enable) show config 2
!−−− This command shows non−default configurations only.
!−−− Issue the show config mod all command in order to
!−−− show both default and non−default configurations.
............................
begin
!
# ***** NON−DEFAULT CONFIGURATION *****
!
!
•