User guide

4-19
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 4 Controller Menu Bar Selection
Ports
Ports
Use CONTROLLER > Ports to navigate to this page.
This page displays the status of each physical port on the controller, and also indicates whether Port
Mirroring is enabled or disabled.
The following table provides a description and the range for each parameter.
Table 4-13 Summary Parameters
Parameter Description Range
Port No Port number on the controller. 13 for optional 1000Base-T or
1000Base-SX module
25 for optional 1000Base-T or
1000Base-SX module
1 for Cisco 4100 Series Wireless LAN
Controller 1000Base-SX port(s)
STP Status State of the Spanning Tree Protocol
Administrative Mode associated with the
port.
Enabled
Disabled
Forwarding
Admin Status Displays the state of the port. Enable
Disable
Physical Mode Displays the configuration of the port
physical interface.
Auto
100 Mbps Full Duplex
100 Mbps Half Duplex
10 Mbps Full Duplex
10 Mbps Half Duplex
Note In a Cisco NMWLC6
controller, the physical mode is
always set to “Auto”.
Physical Status Displays the actual port physical
interface.
Auto
100 Mbps Full Duplex
100 Mbps Half Duplex
10 Mbps Full Duplex
10 Mbps Half Duplex
Link Status Displays the status of the link. Link Up
Link Down
Link Trap Displays if the port is set to send a trap
when link status changes.
Enable
Disable