User guide

4-13
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 4 Controller Menu Bar Selection
Static Mobility Group Members
Static Mobility Group Members
Use CONTROLLER > Mobility Management > Mobility Groups to navigate to this page.
This page lists existing Mobility Group members by MAC Address and IP Address, and also indicates
whether the Mobility Group member is Local (this controller) or remote (any other Mobility Group
member). The first entry is the local controller, which cannot be deleted. The following entries are other
controllers in the mobility group, that can be deleted at any time using the Remove link.
Note You can ping any of the static mobility group members using the Ping link.
The RF Mobility Group Domain Name is set on the General page.
Command Buttons
• New: Select to add a new Mobility Group member.
• Edit All: Display the Mobility Group Member > Edit All page.
• Help: Request that the help page be displayed in a new browser window.
Mobility Group Member > New
Use CONTROLLER > Mobility Management > Mobility Groups then click New to navigate to this
page.
This page allows you to add mobility group members by IP Address and MAC Address.
Command Buttons
• Back: Return to the previous window.
• Apply: Data is sent to the controller and made to take effect, but not preserved across a power cycle;
these parameters are stored temporarily in volatile RAM.
• Help: Request that the help page be displayed in a new browser window.
Mobility Group Member > Edit All
Use CONTROLLER > Mobility Management > Mobility Groups then click Edit All to navigate to
this page.
This page allows you to edit all the existing Mobility Group members’ MAC Addresses and
IP Addresses in a text box, and then to cut and paste all the entries from one controller to the other
controllers in the mobility group.
You can edit existing entries in the box and/or paste new entries into the box. In all cases, leave one space
between the MAC address and IP address on each line.
The text box on this page makes it easy to avoid data-entry errors while copying the mobility group
members list to all the controllers in the same mobility group:
1. Notice that the text box starts with the local controller MAC address and IP address.