User guide

4-8
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 4 Controller Menu Bar Selection
Interfaces
Command Buttons
Back: Return to the previous window.
Ta b l e 4 - 5 Controller Service Port Interface Parameters
Parameter Description
DHCP Protocol Check the check box to have the Service Port interface use a DHCP
server to obtain its IP address.
IP Address The IP address of the Service Port interface.
Netmask Interface subnet mask.
Note The service port cannot be configured with the same IP address nor on the same subnet as the
network distribution system.
Ta b l e 4 - 6 Controller Virtual Interface Parameters
Parameter Description
IP Address Gateway IP address. Any fictitious, unassigned IP address (such as
10.1.10.1) to be used by Layer 3 Security and Mobility managers.
Reboot the controller to have this change take effect.
DNS Host Name Gateway host name. Used by Layer 3 Security and Mobility
managers to verify the source of certificates when Web Auth is
enabled. Reboot the controller to have this change take effect.
Note You must configure the Virtual Gateway Address to enable Layer 3 Web Auth, configured on
the WLANs > Edit page.
Ta b l e 4 - 7 Controller LWAPP Layer 3 Access Point Management Interface Parameters
Parameter Description
VLAN Identifier Virtual LAN assigned to the interface.
IP Address The IP address of the controller Layer 3 LWAPP protocol manager.
Note that this IP address cannot be the same as used by the
Management Interface.
Netmask Interface subnet mask.
Gateway Interface gateway router IP address.
Port Number The controller physical port for this interface.
Primary DHCP Server The interface uses this DHCP server first to obtain an IP address.
Secondary DHCP Server The interface uses this DHCP server as a backup to obtain an
IP address.
ACL Name Any of the Access Control List Names currently available on the
Access Control Lists page.
Note You may only create a Layer 3 LWAPP Access Point manager after the controller has been
rebooted to use Layer 3 LWAPP protocol.