User guide

2-32
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 2 Monitor Menu Bar Selection
Clients
Command Buttons
• Back: Return to the previous window.
• Apply: Data is sent to the controller and made to take effect, but not preserved across a power cycle;
these parameters are stored temporarily in volatile RAM.
• Link Test: Use the built-in test circuitry to test the link between the client and the controller, report
the Client MAC Address, and report the number of test packets sent and received, the local signal
strength, and the local signal to noise ratio in a popup window. Note that the LinkTest does not work
for IPSec links, and may not work for some clients.
• Remove: Disconnect the client.
• Help: Request that the help page be displayed in a new browser window.
Status Code Client status may be one of the following:
• idle (0) -- normal operation: no rejections of client association requests.
• aaaPending (1) -- completing an aaa transaction.
• authenticated (2) -- 802.11 authentication completed.
• associated (3) -- 802.11 association completed.
• powersave (4) -- client in powersave mode.
• disassociated (5) -- 802.11 disassociation completed.
• tobedeleted (6) -- to be deleted after disassociation.
• probing (7) -- client not associated or authorized yet.
• disabled (8) -- automatically disabled by Operating System for an
operator-defined time.
CF Pollable When this attribute is implemented, it indicates that the client is able to
respond to a CF-Poll with a data frame within a SIFS time. This attribute is
not implemented if the STA is not able to respond to a CF-Poll with a data
frame within a SIFS time.
CF Poll Request Specifies whether CFP is requested by the client.
Short Preamble This attribute, when true, indicates that the short preamble option as defined
in subclause 18.2.2.2 is implemented. This parameter must be Disabled to
optimize this controller for some clients, including SpectraLink NetLink
Telephones.
PBCC This attribute, when true, indicates that the PBCC modulation option as
defined in subclause 18.4.6.6 is implemented. The default value of this
attribute is not implemented.
Channel Agility Physical channel agility functionality is or is not implemented.
Timeout Client Session timeout. Sets the maximum amount of time allowed a client
before it is forced to re-authenticate.
WEP State WEP security state of the client.
Table 2-25 AP Properties (continued)
Parameter Description