User guide

2-29
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 2 Monitor Menu Bar Selection
Clients
Interface User-defined name for this interface; for example, management,
service-port, virtual.
VLAN ID The VLAN tag identifier, or 0 for no VLAN tag.
Mobility Role Local when the client has not roamed from its original controller, or when
the client has roamed to another controller on the same subnet.
Foreign when the client has roamed from its original controller to another
controller on a different subnet.
Anchor when the client has roamed back to its original controller after
roaming to another controller on a different subnet.
Mobility Peer IP Address N/A when the client is Local (has not roamed from its original subnet).
Anchor IP Address (the IP address of the original controller) when the client
is Foreign (has roamed to another controller on a different subnet).
Foreign IP Address (the IP address of the original controller) when the client
is Anchor (has roamed back to another controller on a different subnet).
Policy Manager State DHCP_REQD when a DHCP server is required to complete the security
policy.
8021X_REQD when 802.1X is the required policy.
Other messages to be determined.
Mirror Mode Enable or disable Mirror Mode.
Table 2-22 Security Information
Parameter Description
Security Policy
Completed
No, when the security policy checks have not been completed, or Yes, when
the security policy checks have been completed.
Policy Type Security Policy Type, for example, 802.1X
Encryption Cipher WEP 802.1X data encryption type:
40/64 bit key.
104/128 bit key.
128/152 bit key.
Policy Type The Policy Type being enforced by the access point.
Encryption Cipher The encryption format being used by the Cisco WLAN Solution WLAN,
such as WEP.
EAP Type N/A for none, more messages TBD.
Table 2-21 Client Properties (continued)
Parameter Description