User guide

2-28

Cisco WLAN Controller Web Interface User Guide

OL-7416-04

Chapter 2 Monitor Menu Bar Selection

Clients

Use MONITOR > Wireless > Clients or MONITOR > Summary > Current Clients Detail or

WIRELESS > Clients to navigate to this page. This page displays information about the clients

associated with the access points.

Search by MAC Address

You can search the client list by MAC address.

Enter the MAC address as 6 two-digit hexadecimal numbers separated by colons--for example,

01:23:45:67:89:AB. Then click the Search button. If the address exists, that entry is displayed as

the first entry followed by the remaining (greater) MAC addresses. An exact match is required.

Client Information Table

This table displays a list of all clients attached to the . Client information includes:

• MAC Address of the client.

• Name of the access point to which client is attached.

• MAC Address of the access point.

• Name of WLAN used by the client.

• The type of client (802.11a, 802.11b or 802.11g).

• Status of the client connection.

• Authorization status.

• Port number of the client’s associated access point.

Select the Detail link to display the Clients > Detail page.

Select LinkTest to test the link to the Client, report the Client MAC Address, and report the number of

test packets sent and received, the local signal strength, and the local signal to noise ratio in a popup

window. Note that the LinkTest does not work for IPSec links, and may not work for some clients.

Select Disable to manually disable a client on the Disabled Client > New page.

Select the Remove link to dissociate the Client.

Clients > Detail

Use MONITOR > Wireless > Clients then click Detail to navigate to this page.

This page displays the details of the select client’s session, and allows you to enable or disable Mirror

Mode for this client. Information is displayed for both the client and its associated access point.

Table 2-21 Client Properties

Parameter Description

MAC Address MAC address of the client.

IP Address IP address of the client.

User Name Login client name from RADIUS or controller authentication.

Port Number Controller port used for the client’s associated access point.