User guide

2-23

Cisco WLAN Controller Web Interface User Guide

OL-7416-04

Chapter 2 Monitor Menu Bar Selection

Radio > Statistics

Use MONITOR > Wireless > 802.11a Radios or MONITOR > Wireless > 802.11b Radios and then

click Detail to navigate to this page.

This page displays the RF (Radio Frequency) statistics for the selected Cisco radio. You can alternate

between the Graphics View and the Text View clicking the Graphics View/Text View button. You can

view and refresh the following statistics by selecting them (using the checkboxes) and then clicking the

Refresh button on the data page:

• Profile Information.

• Rx Neighbors.

• 802.11 MAC Counters.

This page also displays the following access point variables:

• AP Name.

• AP MAC Address.

• AP IP Address - Only shows an IP address if the controller LWAPP protocol is set for Layer 3 on

the General page, otherwise Disabled.

• Radio Type (802.11a or 802.11b/g).

• Operational Status - Displays the operational status of the Cisco radios, either UP or DOWN.

• Monitor Only Mode (Cisco Aironet 1000 Series lightweight access point) Status - Local (Cisco

Aironet 1000 Series lightweight access point in same-subnet mode or in Rogue Detector mode),

Cisco 1030 remote edge lightweight access point (Cisco Aironet 1030 IEEE 802.11a/b/g remote

edge lightweight access point), or Monitor (Cisco Aironet 1000 Series lightweight access point in

monitor-only mode).

• Current Channel Number.

Profile Information - Graphics View and Text View

The RF statistics are used to derive the Radio Resource Management (RRM) profile for each Cisco radio

in your network. The controller uses the Radio Resource Management (RRM) profile to adjust the Cisco

radio transmit and receive levels in order to maintain the most efficient configuration for your network.

This data view also displays the RF properties of the controller and its clients.

• The Radio Resource Management (RRM) PASSED/FAILED thresholds are globally set for all

access points in the 802.11a Global Parameters > Auto RF and 802.11b/g Global Parameters > Auto

RF pages.

• The Radio Resource Management (RRM) PASSED/FAILED thresholds are Individually set for this

access point in the 802.11 AP Interfaces > Performance Profile page.