User guide

2-16
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 2 Monitor Menu Bar Selection
Known Rogue APs > New
Known Rogue APs > New
Use MONITOR > Wireless > Known Rogue APs or Wireless > Rogues > Known Rogue APs and
then click New to navigate to this page. This page allows you to add an access point to the Known Rogue
APs list.
To add an access point, perform these steps:
Step 1 Enter the MAC address of the access point in the MAC Address field.
Step 2 Click Apply button to bring up the Known Rogue APs page where the access point that you added is
displayed.
Known Rogue AP Detail
Use MONITOR > Wireless > Known Rogue APs or Wireless > Rogues > Known Rogue APs and
then click Edit to navigate to this page.
This page displays the details of the authorized or known rogue access point.
The following information is provided:
Table 2-14 Known Rogue AP Detail
Parameter Description
MAC Address Media Access Control of the known rogue access point.
Type Rogue Access Point Type:
AP = Infrastructure Access Point
Ad Hoc = Client-to-Client
Is Rogue on Wired
Network?
Yes or No. Unknown if WEP is enabled.
First Time Reported On Date and time the radio was first scanned by the controller.
Last Time Reported On Date and time the radio was last scanned by the controller.