User guide

8-10
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 8 Commands Menu Bar Selection
Using the Configuration Wizard
Virtual Interface Configuration
1. The IP Address box contains the default Virtual Interface IP address. Enter a different Virtual
Interface IP address. Note that the Virtual Interface uses any fictitious, unassigned IP address (such
as 1.1.1.1) to be used by Layer 3 Security and Mobility managers.
2. The DNS Host Name box contains a space for a Web Auth ID Certificate DNS Host Name. If the
controller uses an externally-generated Web Auth ID Certificate that includes a DNS Host Name,
enter the DNS Host Name here.
3. Click Next to have the controller save your inputs and display the WLAN Policy Configuration
page, in which you will configure the WLAN 1 parameters.
WLAN Policy Configuration
Refer to the WLANs > Edit page for a description of these parameters.
1. The WLAN SSID box contains the current WLAN 1 SSID. If desired, enter a different SSID.
2. The Radio Policy box contains the default bands controlled by the WLAN 1 policy. If desired, enter
a different WLAN 1 policy: 802.11a only, 802.11g only, 802.11b/g only, 802.11a/g only, or All.
3. The Admin Status box contains the default administrative status (unchecked, or disabled). If desired,
enable the WLAN 1 policy by checking the Admin Status box.
4. The Session Timeout box contains the default 802.11 session timeout (0, or no timeout). If desired,
enter a different 802.11 session timeout in minutes.
5. The Quality of Service (QoS) box contains the default QoS status (Silver, or Best Effort QoS). If
desired, enter a different QoS: Platinum = Voice, Gold = Video, Bronze = Background, or leave as
Silver = Best Effort. VoIP clients should be set to Platinum, Gold or Silver, while low-bandwidth
clients can be set to Bronze.
6. The Allow AAA Override box contains the default AAA Override status (unchecked, or disabled).
If desired, enable AAA Override by checking the AAA Override box.
7. The Blacklist Exclusion List Timeout box contains the default client Exclusion List (blacklist)
timeout status (checked, or enabled). If desired, disable Exclusion List (Blacklist) Timeout by
unchecking the Blacklist Timeout box.
8. When Blacklist (Exclusion List) Timeout is enabled, enter the number of seconds a client is added
to the Exclusion List (blacklisted) upon failing to authenticate three consecutive times.
9. The DHCP Server Override box contains the current status (unchecked, or disabled). If desired,
enable DHCP Server Override by checking the Override box.
10. The DHCP Addr. Assignment Required box contains the current status (unchecked, or not required).
If desired, enable DHCP Address Assignment Required parameter by checking the Required box.
11. The Interface Name box contains the current WLAN 1 Interface (management). Leave this setting
unchanged.
12. The Layer 2 Security box contains the default Layer 2 Security setting (802.1X). If desired, select
a different Layer 2 Security setting: None, WPA, 802.1X, Static WEP, Cranite, or Fortress. Refer to
the WLANs > Edit page for a description of these parameters, and the related parameters that can
be set for Layer 2 Security.