User guide

8-7
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 8 Commands Menu Bar Selection
Using the Configuration Wizard
Using the Configuration Wizard
When the controller is activated for the first time from the factory, or when it has been rebooted after a
Reset to Factory Default, the Web User Interface displays the Web Configuration Wizard. Use the
Configuration Wizard to configure the controller for initial operation.
Perform the following steps to enter the initial controller configuration:
• Collect the Initial Configuration Settings
• Connect Your Web Browser to a Controller
• Configuration Wizard System Information
• Service Interface Configuration
• Management Interface Configuration
• Miscellaneous Configuration
• Virtual Interface Configuration
• WLAN Policy Configuration
• RADIUS Server Configuration
• 802.11 Configuration
• Configuration Wizard Completed
Collect the Initial Configuration Settings
Collect the high-level controller parameters:
System Parameters
– Controller name.
– Supported protocols: 802.11a and/or 802.11b/g.
– New usernames and passwords (optional).
Network (Distribution System) Parameters
– Distribution System (network) port static IP Address, netmask, and optional default gateway IP
Address from the network planner.
– Service port static IP Address and netmask from the network planner (optional).
– Distribution System physical port (1000Base-T, 1000Base-SX, or 10/100Base-T). Note that the
1000Base-SX (UNUSED PRODUCT) provides a 100/1000 Mbps wired connection to a
network through an 850nM (SX) fiber-optic link using an LC physical connector.
– Distribution System port VLAN assignment (optional).
– Distribution System port Web and Secure Web mode settings, enabled or disabled.
– Distribution System port Spanning Tree Protocol: enabled/disabled, 802.1D/fast/off mode per
port, path cost per port, priority per port, bridge priority, forward delay, hello time, maximum
age.