User guide

7-12
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 7 Management Menu Bar Selection
SNMP Trap Controls
Command Buttons
• Apply: Data is sent to the controller and made to take effect, but not preserved across a power cycle;
these parameters are stored temporarily in volatile RAM.
• Help: Request that the help page be displayed in a new browser window.
Trap Logs
Use MANAGEMENT > SNMP/Trap Logs to navigate to this page.
You can view the traps logs which have been captured by the controller. Each trap entry includes the Log
Number, System Time, and Trap Description.
This screen also displays the number of traps since Last Reset and number of traps since Log Last
Viewed.
Note Review the following Client Reason and Status Codes shown below. You are likely to encounter them
when reviewing the Trap Logs.
IKE Suite Failure An attempt to negotiate a phase 2 SA suite for the specified selector
failed. The current total failure counts are passed as well as the
notification type counts for the notify involved in the failure.
Invalid Cookie ISAKMP packets with invalid cookies were detected from the specified
source, intended for the specified destination. The initiator and responder
cookies are also sent with the trap.
Ta b l e 7- 17 8 0 2 . 11 S e c u ri t y Tr a p s
Trap Name Description
WEP Decrypt Error This trap is to inform that an error has occurred while a WEP entity is being
decrypted.
Ta b l e 7- 18 W P S Tra p s
Trap Name Description
Rogue Auto Containment An AP which is being contained will either not be able to provide service at
all, or will provide exceedingly slow service.
Table 7-16 IP Security Traps (continued)
Trap Name Description