User guide

7-11
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 7 Management Menu Bar Selection
SNMP Trap Controls
Table 7-13 Auto RF Profile Traps
Trap Name Description
Load Profile Notification sent when Load Profile state changes between PASS and
FAIL.
Noise Profile Notification sent when Noise Profile state changes between PASS and
FAIL.
Interference Profile Notification sent when Interference Profile state changes between PASS
and FAIL.
Coverage Profile Notification sent when Coverage Profile state changes between PASS and
FAIL.
Table 7-14 Auto RF Update Traps
Trap Name Description
Channel Update Notification sent when the access point’s dynamic channel algorithm is
updated.
Tx Power Update Notification sent when the access point’s dynamic transmit power
algorithm is updated.
Antenna Update Notification sent when the access point’s dynamic antenna algorithm is
updated.
Table 7-15 AAA Traps
Trap Name Description
User Authentication This trap is to inform that a client RADIUS authentication failure has
occurred.
RADIUS Servers Not
Responding
This trap is to indicate that no RADIUS server(s) are responding to
authentication requests sent by the RADIUS client.
Table 7-16 IP Security Traps
Trap Name Description
ESP Authentication Failure IPSec packets with invalid hashes were found in an inbound ESP SA.
ESP Replay Failure IPSec packets with invalid sequence numbers were found in an inbound
ESP SA.
Invalid SPI A packet with an unknown SPI was detected from the specified peer with
the specified SPI using the specified protocol.
IKE Negotiation Failure An attempt to negotiate a phase 1 IKE SA failed. The notification counts
are also sent as part of the trap, along with the current value of the total
negotiation error counters.