User guide

7-10
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 7 Management Menu Bar Selection
SNMP Trap Controls
SNMP Trap Controls
Use MANAGEMENT > SNMP > Trap Controls to navigate to this page.
This page allows you to select which traps logs should be captured. Select the applicable logs and select
Apply.
Table 7-10 Miscellaneous Traps
Trap Name Description
SNMP Authentication The SNMPv2 entity has received a protocol message that is not properly
authenticated.
Link (Port) Up/Down Port changes status from up or down.
Multiple Users Two users login with the same login ID.
Spanning Tree Spanning Tree traps. Refer to the STP specifications for descriptions of
individual parameters.
Rogue AP Whenever a rogue access point is detected this trap is sent with its MAC
Address; When a rogue access point that was detected earlier and it no
longer exists this trap is sent.
Config Save Notification sent when the configuration is modified.
Ta b l e 7- 11 C l i e n t R e l a t e d Tra p s
Trap Name Description
802.11 Disassociation The disassociate notification is sent when the client sends a disassociation
frame.
802.11 Deauthentication The deauthenticate notification is sent when the client sends a
deauthentication frame.
802.11 Failed
Authentication
The authenticate failure notification is sent when the client sends an
authentication frame with a status code other than 'successful'.
802.11 Failed
Association
The associate failure notification is sent when the client sends an association
frame with a status code other than 'successful'.
Exclusion The associate failure notification is sent when a client is Exclusion Listed
(blacklisted).
Table 7-12 Cisco AP Traps
Trap Name Description
AP Register Notification sent when the access point associates or disassociates with the
controller.
AP Interface Up/Down Notification sent when the access point interface (802.11a or 802.11b/g)
status changes to up or down.