User guide

7-7
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 7 Management Menu Bar Selection
SNMP v1/v2c Community
SNMP v1/v2c Community > Edit
Use MANAGEMENT > SNMP Communities then click Edit to navigate to this page.
Use this page to Enable or Disable an SNMP community profile. All fields are read-only except the
Status field.
Command Buttons
• Back: Return to the previous window.
• Apply: Data is sent to the controller and made to take effect, but not preserved across a power cycle;
these parameters are stored temporarily in volatile RAM.
• Help: Request that the help page be displayed in a new browser window.
Table 7-7 SNMP Community Summary
Parameter Range
Community Name The community string to which this entry grants access. A valid entry is a
case-sensitive alphanumeric string of up to 16 characters. Each row of this
table must contain a unique community name.
IP Address An IP address from which this device accepts SNMP packets with the
associated community. The requesting entity's IP address is ANDed with the
Subnet Mask before being compared to the IP Address.
Note If the Subnet Mask is set to 0.0.0.0, an IP Address of 0.0.0.0 matches
all IP addresses. The default value is 0.0.0.0.
IP Mask A mask to be ANDed with the requesting entity's IP address before
comparison with IP Address. If the result matches with IP Address then the
address is an authenticated IP address. For example, if the IP Address =
9.47.128.0 and the corresponding Subnet Mask = 255.255.255.0 a range of
incoming IP addresses would match, that is, the incoming IP Address could
equal 9.47.128.0 - 9.47.128.255. The default value is 0.0.0.0.
Access Mode The access level for this community string. May be specified by selecting
Read/Write or Read Only from the pull-down.
Status Set the status of this community access entry. When this object is set to
enabled, if the Community Name for this row is not unique among all valid
rows, the set request is rejected. Community names may be made invalid by
selecting disable.