User guide

7-5

Cisco WLAN Controller Web Interface User Guide

OL-7416-04

Chapter 7 Management Menu Bar Selection

SNMP v1/v2c Community

Use MANAGEMENT > SNMP > Communities to navigate to this page.

This page provides a summary of the SNMP community as described in the following table.

Edit a user profile by selecting the Edit link (SNMP v1/v2c Community > Edit).

Remove a user profile by selecting the appropriate Remove link. You are prompted for confirmation of

the user removal.

Command Buttons

• New: Select to add a new community user profile (SNMP v1/v2c Community > New).

• Help: Request that the help page be displayed in a new browser window.

Table 7-5 SNMP Community Summary

Parameter Range

Community Name The community string to which this entry grants access. A valid entry is a

case-sensitive alphanumeric string of up to 16 characters. Each row of this

table must contain a unique community name.

IP Address An IP address from which this device accepts SNMP packets with the

associated community. The requesting entity's IP address is ANDed with the

Subnet Mask before being compared to the IP Address.

Note If the Subnet Mask is set to 0.0.0.0, an IP Address of 0.0.0.0 matches

all IP addresses. The default value is 0.0.0.0.

IP Mask A mask to be ANDed with the requesting entity's IP address before

comparison with IP Address. If the result matches with IP Address then the

address is an authenticated IP address.

For example, if the IP Address = 9.47.128.0 and the corresponding Subnet

Mask = 255.255.255.0 a range of incoming IP addresses would match, that

is, the incoming IP Address could equal 9.47.128.0 - 9.47.128.255. The

default value is 0.0.0.0.

Access Mode The access level for this community string. May be specified by selecting

Read/Write or Read Only from the pull-down.

Status The status of this community access entry. When this object is set to enabled,

if the Community Name for this row is not unique among all valid rows, the

set request is rejected.