User guide

7-4
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 7 Management Menu Bar Selection
SNMP V3 Users
SNMP V3 Users
Use MANAGEMENT > SNMP > SNMP V3 Users to navigate to this page.
This page provides a summary of the SNMP users as described in the following table.
Remove a user profile by selecting the appropriate Remove link. You are prompted for confirmation of
the user removal.
Command Buttons
• New: Select to add a new SNMP user (SNMP V3 Users > New).
• Help: Request that the help page be displayed in a new browser window.
SNMP V3 Users > New
Use MANAGEMENT > SNMP > SNMP V3 Users then click New to navigate to this page.
This page provides a summary of the SNMP users as described in the following table.
If you select an authentication or privacy protocol, you must enter a password for each.
Command Buttons
• Back: Return to the previous window.
• Apply: Data is sent to the controller and made to take effect, but not preserved across a power cycle;
these parameters are stored temporarily in volatile RAM.
• Help: Request that the help page be displayed in a new browser window.
Table 7-3 SNMP User Summary
Parameter Range
User Name Name of the user profile.
Access Level Read Only; Read Write.
Auth Protocol None; HMAC-MD5; HMAC-SHA.
Privacy Protocol None; CBC-DES.
Table 7-4 SNMP User Details
Parameter Range
User Profile Name Name of the user profile.
Access Mode Read Only or Read Write.
Authentication Protocol None, HMAC-MD5, or HMAC-SHA.
For HMAC-MD5 or HMAC-SHA, enter and confirm an
Authentication Password.
Privacy Protocol None or CBC-DES.
For CBC-DES, enter and confirm a Privacy Password.