User guide

7-3

Cisco WLAN Controller Web Interface User Guide

OL-7416-04

Chapter 7 Management Menu Bar Selection

SNMP System Summary

Use MANAGEMENT > SNMP > General to navigate to this page.

This page allows you to change some of the SNMP system parameters.

Command Buttons

• Apply: Data is sent to the controller and made to take effect, but not preserved across a power cycle;

these parameters are stored temporarily in volatile RAM.

• Help: Request that the help page be displayed in a new browser window.

Table 7-2 SNMP System Parameters

Parameter Description

Name Customer definable name of the controller.

Location Customer definable controller location.

Contact Customer definable contact details.

System Description Read-only controller description.

System Object ID Read-only object ID.

SNMP Port Number Read-only SNMP port number.

Trap Port Number Definable trap port number; Default is 162.

SNMP v1 Mode Enable or disable SNMP v1; Default is disable.

SNMP v2c Mode Enable or disable SNMP v2c; Default is disable. This parameter should be

modified if remote management is desired.

SNMP v3 Mode Enable or disable SNMP v3; Default is disable. This parameter should be

modified if remote management is desired.