User guide

6-37
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 6 Security Menu Bar Selection
AP Authentication
AP Authentication
Use SECURITY > Wireless Protection Policies then click AP Authentication to access this page.
This page allows you to set access point authentication policies.
Command Buttons
• Back
• Apply
• Help
Table 6-6 AP Authentication Parameters
Parameter Description
RF Network Name Not an editable field. The RF Network name entered in the general
parameters window (Refer to General) is displayed here.
Enable AP Neighbor
Authentication
Check this check box to enable the AP authentication feature. When this
feature is enabled, the access points sending RRM neighbor packets with
different RF Network Names are reported as rogues.
Alarm Trigger Threshold Set the number of hits to be ignored from a foreign access point before an
alarm is raised.
The valid range is from 1 to 255. The default value is 255.