User guide

6-23
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 6 Security Menu Bar Selection
Access Control Lists
Command Buttons
• Back: Return to the previous window.
• Help: Request that the help page be displayed in a new browser window.
• Add New Rule: Add a new rule to an existing ACL.
Access Control Lists > Rules > Edit
Use SECURITY > Access Control Lists, click Edit and then in the sequence number which you want
to change the rule click Edit again to navigate to this page.
This page allows you to change an ACL rule definition.
Note The Operating System allows you to define up to 64 ACLs, with up to 64 Rules (filters) per ACL.
Table 6-3 Rule Edit Parameters
Parameter Description
Sequence The operator can define up to 64 rules for each ACL.
The rules for each ACL are listed in contiguous sequence from 1 to
64. That is, if Rules 1 through 4 are already defined and you add
Rule 29, it is be added as Rule 5.
Note If you add or change a Sequence number, the Operating
System adjusts the other rule sequence numbers to retain
the contiguous sequence. For instance, if you have
Sequence numbers 1 through 7 defined and change number
7 to 5, the Operating System automatically reassigns
Sequence 6 to 7 and Sequence 5 to 6.
Source Any or IP Address and Netmask.
Destination Any or IP Address and Netmask.
Protocol (Note 1) Protocol to use for this ACL:
Any - All protocols
TCP - Transmission Control Protocol
UDP - User Datagram Protocol
ICMP - Internet Control Message Protocol
ESP - IP Encapsulating Security Payload
AH - Authentication Header
GRE - Generic Routing Encapsulation
IP - Internet Protocol
Eth Over IP - Ethernet over Internet Protocol
OSPF - Open Shortest Path First
Other - Any other IANA protocol (http://www.iana.org/)