User guide

5-36
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 5 Wireless Menu Bar Selection
802.11a Global Parameters
Use Set to Factory Default to set all Auto RF 802.11a parameters to the Factory Defaults.
Command Buttons
• Back: Return to the previous window.
• Apply: Data is sent to the controller and made to take effect, but not preserved across a power cycle;
these parameters are stored temporarily in volatile RAM.
• Help: Request that the help page be displayed in a new browser window.
Table 5-41 Profile Thresholds
Parameter Description
Interference (0 to 100%) Foreign 802.11a interference threshold between 0 and 100 percent.
Clients (1 to 75) Client threshold between 1 and 75 clients.
Noise (-127 to 0 dBm) Foreign noise threshold between -127 and 0 dBm.
Coverage (3 to 50 dBm) 802.11a coverage threshold between 3 and 50 dB.
Utilization (0 to 100%) 802.11a RF utilization threshold between 0 and 100 percent.
Coverage Exception Level
(0 to 100%)
Coverage exception level between 0 and 100 percent.
Data Rate (1 to 1000 Kbps) 802.11a throughput threshold between 1 Kbps and 1000 Kbps.
Client Min Exception Level
(1 to 75)
Client minimum exception level.
Table 5-42 Monitor Intervals
Parameter Description
Noise Measurement The interval (in seconds) for noise and interference measurements at
each access point. Default is 300 seconds.
Load Measurement The interval (in seconds) for load measurements at each access point.
Default is 300 seconds.
Signal Measurement The interval (in seconds) for strength measurements at each access
point. Default is 300 seconds.
Coverage Measurement The interval (in seconds) for coverage measurements at each access
point. Default is 300 seconds.
Note Intervals from 60 to 3600 seconds.