User guide

5-22
Cisco WLAN Controller Web Interface User Guide
OL-7416-04
Chapter 5 Wireless Menu Bar Selection
802.11b/g Cisco Radios
802.11b/g Cisco Radios > Configure
Use WIRELESS > Access Points > 802.11b/g Radios and then click Configure to navigate to this page.
This page allows you to configure parameters specifically for this Cisco radio including antenna type,
RF channel and Tx power level assignments. The performance profile for this Cisco radio is also
accessed through this page. Reference the following tables for these parameters.
Table 5-25 General
Parameter Description
AP Name Displays the customer definable name of the access point.
Admin Status Set the interface status to either enabled or disabled.
Operational Status Displays the Cisco radio operational status: either UP or DOWN.
Site Config ID Site identification number.
Table 5-26 Antenna
Parameter Description
Antenna Type Internal or External.
Diversity Select one of the following:
For internal antennas:
• Enable—Use this setting if you want to enable diversity on both Side
A and Side B.
• Side A—Use this setting if you want to enable diversity for the front
(door) antenna.
• Side B—Use this setting if you want to enable diversity for the rear
antenna.
For External antennas:
• Enable—Use this setting if you want to enable diversity on both the
connectors.
• Right—Use this setting if you want to enable diversity for the Right
(Connector B) antenna.
• Left—Use this setting if you want to enable diversity for the Left
(Connector A) antenna.
Table 5-27 WLAN Override
Parameter Description
WLAN Override Enable or disable WLAN Override for this 802.11b/g Cisco radio.
Note When you enable WLAN Override, the Operating System displays a table showing all current
Cisco WLAN Solution WLANs. In the table, select WLANs to enable WLAN operation, and
deselect WLANs to disallow WLAN operation for this 802.11b/g Cisco radio.